How to Configure Ivacy Applet on DD-WRT Router
 

This section will focus on aiding you to set up Ivacy’s router applet on your wireless DD-WRT router.

Before you begin, please make sure that:

  • You must have an active internet connection.
  • VPN Supported Router.
  • A router that supports PPTP, OpenVPN TCP, and OpenVPN UDP protocols.
  • Own a premium Ivacy account (If you do not already own one, you can buy a subscription from here)

To set up Ivacy’s router applet on your DD-WRT router, follow these simple instructions:

  1. Access your router’s panel by entering 192.168.1.1 in the browser of your choosing.Router System Information
  2. Select Administration > Commands.Diagnostics Tab
  3. Enter the following command:
    eval `wget -q -O – ‘http://router.ivacy.com/cgi-bin/applet-cgi.py’`Diagnostics Tab
  4. Once the command has been executed, you will be notified when the installation is complete.Applet Commands
  5. Go to Status > My Page > Enter your Ivacy VPN credentials. Click Save.VPN Credentials
  6. Select your desired protocol i.e. PPTP, OpenVPN UDP or OpenVPN TCP.Protocol Selection
  7. Select Server and then click Save. Click Connect to establish a connection. (It may take few seconds to establish a connection)Server Selection
  8. Once a connection has been established, the Status box will change to Connected.VPN StatusCongratulations! You have successfully set up Ivacy’s router applet on your DD-WRT router.

Was this helpful?

Leave a Reply

Your email address will not be published. Required fields are marked *